Before Initial Use; Putting Into Operation; Attaching/Removing Attachments - HandHeld HS101 Mode D'emploi

Before Initial Use

CAUTION!
❐ Keep children and animals away from the packaging material. There is a danger of suffo-
cation!
Unpack all parts and check the items supplied for completeness (see the "Items Supplied and
Device Overview" chapter) and transport damage. If you fi nd any damage to the components,
do not use them (!), but contact our customer service department.

Putting Into Operation

(Illustration similar)
Before you can use the device, you must fi rst fi t a nozzle attachment of your choice and pour
water into the water reservoir.

Attaching/Removing Attachments

CAUTION!
❐ Always pull out the mains plug before you remove/change an attachment. Always pull the
plug and never the cable.
❐ Shortly after use, the attachment used may still be very hot. You should therefore wait for
a few minutes until it has completely cooled down before you detach it.
• All accessory attachments can be placed directly onto the device or directly onto
the extension hose!
• The long nozzle can be used as a kind of adapter, i. e. you can place the long nozzle
onto the device or onto the extension hose and place the round brush nozzle and
the bent nozzle onto the long nozzle!
Attaching the Extension Hose/Long Nozzle/Wide Nozzle
1. Place the extension hose, the long nozzle or the wide
nozzle onto the device.
2. Then turn the extension hose, the long nozzle or the
wide nozzle (see marking on the respective attach-
ment) to lock the attachment in place.
3. When you want to remove the attachments, turn the
attachment counter to the arrow marking on the re-
spective attachment and detach it from the device.
21