Aligning The Doors; Connecting The Appliance; Electrical Connection - Siemens KA N Série Notice De Montage Et D'utilisation

Aligning the doors

When you found the doors are not at the same level,
you can use a spanner to adjust the fridge door.
Only the fridge door can be adjusted.
To raise the fridge door, turn the bolt (1) anticlockwise.
To lower the fridge door, turn the bolt (1) clockwise.
Once in position, lock the nut (2).

Connecting the appliance

Have a technician install and connect the appliance
according to the enclosed installation instructions.
Do not remove the transportation protection devices
from the shelves and storage compartments until the
appliance has been installed.
Apart from statutory national regulations, you should
stick to the connection terms relating to the local
electricity company.
After installing the appliance, wait at least 1 hour until
the appliance starts up. During transportation the oil in
the compressor may have flowed into the refrigeration
system.
Before switching on the appliance for the first time,
clean the interior of the appliance
(~ chapter "Cleaning the appliance").

Electrical connection

:
Warning – Risk of electric shock!
If the length of the mains cable is inadequate, never
use multiple sockets or extension leads. Instead,
please contact Customer service for alternatives.
The appliance must be connected to a permanently
installed socket.
The socket must be near the appliance and also freely
accessible following installation of the appliance.
The appliance complies with protection class I.
Connect the appliance to 220-240 V / 50 Hz alter­
nating current via a correctly installed socket with
protective conductor. The socket must be protected
by a 10 A to 16 A fuse or higher.
For appliances operated in non-European countries,
check whether the indicated voltage and current type
match the values of your electricity supply. The rating
plate is situated in the bottom right-hand side of the
appliance. The mains cable may be replaced by a
technician only.
:
Warning
Never connect the appliance to electronic energy saver
plugs.
Our appliances can be used with mains and sine-
controlled inverters. Mains-controlled inverters are used
for photovoltaic systems which are connected directly
to the national grid. Sine-controlled inverters must be
used for isolated applications (e.g. on ships or in
mountain lodges) which are not connected directly
to the national grid.
en
25