Audio Settings - Kenwood KDC-201 Mode D'emploi

AUDIO SETTINGS

While listening to any source...
1
Press the volume knob to enter [FUNCTION].
2
Turn the volume knob to select [AUDIO CTRL], then press the knob.
3
Turn the volume knob to make a selection (see the table below), then press
the knob.
3
Repeat step until the desired item is selected or activated.
4
Press and hold to exit.
• To return to the previous hierarchy, press
SUB-W LEVEL –15 to +15 (0): Adjusts the subwoofer output level.
BASS LEVEL –8 to +8 (0):
Adjusts the level to memorize for each source. (Before
MID LEVEL –8 to +8 (0):
making an adjustment, select the source you want to adjust.)
TRE LEVEL –8 to +8 (0):
PRESET EQ NATURAL/ USER/ ROCK/ POPS/ EASY/ TOP40/ JAZZ/ POWERFUL: Selects
a preset equalizer suitable to the music genre. (Select [USER] to use the
customized bass, middle, and treble settings.)
BASS BOOST B.BOOST LV1/ B.BOOST LV2/ B.BOOST LV3: Selects your preferred bass boost
level. ; OFF: Cancels.
8
.
Default: XX
LOUDNESS LOUD LV1/ LOUD LV2: Selects your preferred low and high frequencies boost
to produce a well‑balanced sound at a low volume level. ; OFF: Cancels.
BALANCE L15 to R15 (0): Adjusts the left and right speaker output balance.
FADER R15 to F15 (0): Adjusts the rear and front speaker output balance.
SUBWOOFER ON: Turns on the subwoofer output. ; OFF: Cancels.
SET/ SUB-W SET
DETAILED SET/ DETAIL SET
LPF SUB-W THROUGH: All signals are sent to the subwoofer. ; 85HZ/ 120HZ/
160HZ: Audio signals with frequencies lower than 85 Hz/ 120 Hz/ 160 Hz are
sent to the subwoofer.
SUB-W PHASE REV (180°)/ NORM (0°): Selects the phase of the subwoofer output to be in
line with the speaker output for optimum performance. (Selectable only if a
setting other than [THROUGH] is selected for [LPF SUB-W].)
SUPREME SET ON: Creates realistic sound by interpolating the high‑frequency components
that are lost in Audio file audio compression. ; OFF: Cancels. (Selectable only
when playing back an Audio file disc, a USB device, or the iPhone/iPod.)
VOL OFFSET –8 to +8 (for AUX) ; –8 to 0 (for other sources): Presets the volume
(Default: 0) adjustment level of each source. (Before adjustment, select the source you
want to adjust.)
• [SUB-W LEVEL]/ [SUB-W SET]/ [LPF SUB-W]/ [SUB-W PHASE] is selectable only if
[SWITCH PRE] is set to [SUB-W]. (➜ 4)
• [SUB-W LEVEL]/ [LPF SUB-W]/ [SUB-W PHASE] is selectable only if [SUB-W SET] is set
to [ON].