LENCO KCR-200 Mode D'emploi page 13

Recall Stored FM Presets (Through Menu Operation)
1. Press and hold the INFO / MENU button on the unit (or press the MENU button on the remote control) to access the menu
operation.
2. Press the or button on the unit (the
press ENTER button.
3. Press the or
want to recall. Then press the ENTER button to tune to the preset station number.
Stereo / Force Mono Selection
When receiving a Stereo FM radio channel, press the ST/MONO button will switch between stereo audio and force mono audio.
Note:
The antenna wire at the rear panel of the unit should be fully extended to ensure a good reception. Alter the antenna position for
-
the best reception.
Displaying FM Station Information
There are several types of information as listed below. To change the display information, press the INFO / MENU button (the INFO
button on the remote control) repeatedly.
1. Radio Text
Scrolling text which shows information on music titles or program details provided by the radio station
2. Program Type (PTY)
Type of program provided by the broadcaster
3. Frequency
Current channel frequency
4. Audio Type
Stereo or Mono
5. Time
Displays the current time provided by the radio station
6. Date
Displays the current date provided by the radio station
OTHER FM MENU OPERATION
Press and hold the INFO / MENU button on the unit (or press the MENU button on the remote control) to access the menu control.
Then press the or
Scan Setting
1. Press and hold the INFO / MENU button on the unit (or press the MENU button on the remote control) to access the menu control.
2. Press the or button until "Scan setting" is displayed and then press the ENTER button.
3. Press the or
confirm. When "All stations" is selected, all stations will be detected during FM scanning even if the radio station is noisy. When
the "Strong station" is selected, only the strong stations are detected. Scanning will ignore the noisy stations.
4. The next time doing a FM scan the unit will search for the stations based on this confirmed setting.
Audio Setting
1. Press and hold the INFO / MENU button on the unit (or press the MENU button on the remote control) to access the menu control.
2. Press the or button until "Audio setting" is displayed and then press the ENTER button.
3. Press the or button to toggle between "Stereo allowed" or "Forced mono" selection and then press the ENTER button
confirm.
button on the unit (the TUNE
button for different options as described below.
button to toggle between "All stations" or "Strong station" selections and then press the ENTER button
or button on the remote control) until "Preset Recall" is displayed and then
/ TUNE button on the remote control) to a preset number that you
13
"S" for Stereo
"M: for Mono