Technical Data - Husqvarna PA1100 Manuel D'utilisation

To check the chain lubrication
1. Check the chain lubrication each time you refuel.
Aim the tip of the bar at a light coloured surface
about 20 cm (8 inches) away. After 1 minute running
at 75% throttle you should see a distinct line of oil on
the light surface.
To adjust chain lubrication
WARNING: Stop the engine/motor before
you make adjustments to the oil pump.
Turn the adjustment screw for the oil pump. Use a
screwdriver or combination wrench.
• Turn the adjuster screw clockwise to increase the oil
flow.
Technical data for gasoline operated products
Lubrication system
Oil tank capacity, l
Weight
Weight, kg
Noise emissions
Sound power level, measured dB (A)
Sound power level, guaranteed L
14

Technical data

dB (A)
WA
• Turn the adjuster screw anticlockwise to decrease
the oil flow.
To do a check if lubrication does not work
1. Check that the oil channel in the bar is not
obstructed. Clean if necessary.
2. Check that the oil channel in the gear housing is
clean. Clean if necessary.
3. Check that the bar tip sprocket turns freely. If the
chain lubrication system is still not working after
carrying out the above checks you should contact
your service workshop.
PA1100
0.15
1.4
110
111
748 - 001 - 17.01.2020