Transport Of The Machine; Electrical Connection - Scheppach HS720 Traduction Des Instructions D'origine

11. Transport of the machine

Rocker lock
• To transport the rocker circular saw lock in place the rocker lock in position (1) and pull on the handle (2).
1
12. m Electrical Connection
The electrical motor installed is connected and ready for operation. The connection complies with the applicable VDE
and DIN provisions. The customer's mains connection as well as the extension cable used must also comply with these
regulations.
Check electrical connection cables regularly for damage. Ensure that the connecting cable is not attached to the mains
when you are checking it.
Electrical connecting cables must correspond to the relevant VDE and DIN regulations. Only use connecting cables with
the code H 07 RN.
The type designation must be printed on the connecting cable by regulation.
Faulty electrical connecting cables
Insulation damage often occurs at electrical connecting cables.
Causes include:
Pinch points when connecting cables are run through window or door gaps.
Kinks resulting from incorrect attachment or laying of the connection cable.
Cuts resulting from running over the connecting cable.
Insulation damage resulting from forcefully pulling out of the wall socket.
Cracks through aging of insulation.
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
When transporting the rocking frame circular saw with petrol en-
gine, insert the transport handle (3) through 2 loops and, for
safety, slightly turn it, and lift and transport it using the transport
handle..
2
3
GB 25