Danby Maitre'D DWC1233BL-SC Manuel Du Propriétaire page 4

Part Identification
1. Glass Door
2. Control Panel
3. LCD Display
4. Interior Light ( not shown )
5. Wine Racks
6. Door Hinge Cover
7. Adjustable Feet
1 2
7
I N S T A L L A T I O N
3 6
5
Location Requirements
• Select a location with a strong, level floor.
• Allow 5 inches of space between the back of the
appliance and any adjacent wall.
• Avoid direct sunlight and heat. Direct sunlight may
affect the acrylic coating, heat sources nearby will
cause higher electricity consumption.
• Do not use this appliance outdoors: This
appliance is intended for household use only . Do
not attempt to operate or store this appliance
outdoors.
• Do not build this appliance into an enclosure: This
appliance is
application only and is not intended to be "built-in".
Before Using your Wine Cooler
• Remove the exterior and interior packing
• Check to be sure the following parts are included:
• 3 Slide-out shelves.
• Before connecting the appliance to the power
source, let it stand upright for approximately 2
hours. This will reduce the possibility of a
malfunction in the cooling system from handling
during transportation.
• Clean the interior surface with lukewarm water
using a soft cloth.
• Place your appliance on a floor that is strong
enough to support the appliance when it is fully
loaded. To level your appliance, adjust the front
legs at the bottom of the appliance.
3
designed for a free-standing