Agri-Fab 45-04561 Manuel Du Propriétaire page 8

29. Flip the dump tube (5) forward to rest on top of the
hopper bag.
30. Snap the dump handle clip (33) onto the pivot rod.
31. Slide the handle grip (29) onto the end of the handle
tube (9) as shown in figure 17.
32. Assemble the handle tube (9) to the dump tube (5)
and secure in place with a 1/4" x 1" curved head bolt
(26) and 1/4" nylock nut (24). See figure 17.
29
9
33. To attach the hopper bag to the sweeper, slide the
pivot rod in the bag into the ends of the bag arm
channels, locking it in the pivot rod retainers. The
channels go inside the bag. See figure 18.
HINT: Temporarily loosen the plastic wing nuts (31) if
necessary to fit the channels inside the bag.
5
33
26
24
FIGURE 17
31
FIGURE 18
ATTACHING SWEEPER HITCH TO TRACTOR
1. Place the tractor and sweeper on a flat level surface.
2. Set the sweeper height adjustment handle to about
the middle of its adjustment range.
3. Attach the sweeper hitch to the tractor hitch, leveling
the bag by arranging the spacers as shown in the
GROUP A, GROUP B and GROUP C diagrams in
figure 20.
APPROXIMATELY LEVEL
(6" to 8" FROM SURFACE)
4. Arrange the spacers into one of the three possible
combinations as shown below in the GROUP A,
GROUP B and GROUP C diagrams in figure 20.
IMPORTANT: To obtain the best performance from your
sweeper, arrange the spacers so that the sweeper bag is
approximately level with the ground as shown in figure 19.
GROUP "A" VEHICLES GROUP "B" VEHICLES
WITH HITCHES
HAVING 11" TO 13"
GROUND CLEARANCE. GROUND CLEARANCE.
8
BRUSH HEIGHT ADJUSTED
APPROXIMATELY MID-WAY
FIGURE 19
GROUP "C" VEHICLES
WITH HITCHES WITH HITCHES
HAVING 9" TO 11" HAVING 7" TO 9"
GROUND CLEARANCE.
FIGURE 20