Agri-Fab 45-04561 Manuel Du Propriétaire page 10

CUSTOMER RESPONSIBILITIES
Read and follow the maintenance schedule and the procedures listed in the maintenance section.
MAINTENANCE SCHEDULE
Fill in dates as you
complete regular service.
Check for loose fasteners
Check for worn or damaged parts
Lubricate brush shaft bearings
Lubricate wheel bearings
Clean Sweeper
Clean, inspect and lubricate gears
SCHEDULED MAINTENANCE
1. Clean the sweeper after each use.
2. Inspect for worn or damaged parts, such as brushes
and wheels.
3. Lubricate the brush shaft bearings twice a year with a
few drops of light weight oil.
4. Every year, remove the wheels and clean the teeth
on the gears and wheels. After cleaning, lubricate the
axles and the teeth on the gears and wheels with a
light coat of grease. To remove a wheel, pop off the hub
cap to expose the head of the bolt. Remove the nut and
step spacer from the bolt and then remove the wheel
along with the bolt and washers. When re-assembling,
be sure the step spacer is properly seated in the hole
in the sweeper housing. Refer to "Gear and Drive Pin
Service" and figure 22 on page 11.
Wheels skid when sweeping
MAINTENANCE
X
X X
X
X
X X
X
TROUBLESHOOTING
1. Brushes set too low.
2. Brushes are jammed.
3. Wheels are jammed.
10
Service Dates
CLEANING
1. Clean sweeper housing with a soft brush or cloth.
2. Clean debris from hopper bag with a brush or broom.
3. Remove any material which has wrapped around
brushes or ends of brush shaft.
1. Adjust height till brushes are 1/2" down into grass.
2. Stop sweeper. Remove obstruction.
3. Remove one wheel at a time to check for obstruction or
damage Refer to Service and Adjustments section.