Explore Scientific WSH0002 Mode D'emploi page 8

Hour  Minute  °C/°F  Exit
7. If there is no action in 20 seconds, the setting
will be saved and will exit the setting mode.
ALARM
SETTING/ADJUSTING DUAL ALARM TIME
1. Press the [ ] button to display Alarm.
2. Press and hold [
setting mode.
3. The setting parameter will flash.
4. Press [
the desired data.
5. Press [ ] button to confirm setting and
enter to next parameter.
6. Alarm will turn on automatically when alarm
setting is finished.
TURN ON/OFF ALARM
Press the [ ] button display alarm time, then
press [ ] to turn on/off the alarm.
8
] to enter the alarm
] or [ ] button to set
OPERATION
1. At the set time, alarm signal rings.
2. During the alarm, press the [ SNOOZE ]
button to delay the alarm by 5 minutes.
3. If you do not press any button to stop the
alarm, it will automatically turn off after 2
minutes.
4. To stop the alarm, press any other button
except for [ SNOOZE ].
5. The alarm will start again at the next alarm
time, unless you switch off the alarm
function by pressing the [
TEMPERATURE
The indoor temperature is always displayed in
the middle of the screen. To receive outdoor
temperature, you can connect up to 3 outdoor
sensors to the main unit, press the [
button to toggle between Channel 1-3.
] button.
]