Minebea Intec YDO02C-232 Notice D'installation page 6

YDO02C
6
§ Screw in the 2 spacing bolts
§ Plug the UniCOM interface module into the digital PCB of the indicator. To do this, insert
the connectors on the interface module into the corresponding ports on the digital PCB.
§ Fasten the interface module with the screws.
Interface modules are equipped with screw terminal blocks.
Attach the connection cables to these terminal blocks.
Attach the DSUB connector (IP44 version)
§ Attach the DSUB connector to the corresponding bulkhead receptacle.
§ Plug the flex cable into the UniCOM digital PCB.
SAT