Firmware Upgrade; Checking Ip Settings - Depaepe Telecom SecurPhone IP Notice D'utilisation

SecurPhone IP – User Guide
For both modes:
- Pick up the handset and dial ***
Preferred voice codec:
- dial 07
- after the voice message,
WAN port web access:
- dial 12
- after the voice message,
Firmware server IP address:
- dial 13,
- after the voice
(Ex.192168000251).
Configuration server IP address:
- dial 14,
- after the voice
(Ex.192168000252).
Upgrade protocol:
- dial 15
- after the voice message,

Firmware upgrade:

- dial 17
- after the voice message,
pre/suffix changes' and 'Never upgrade'.
Reset: (pay attention, this operation will delete all configuration information)
- dial 99
- after the voice message,
restore standard factory settings.

4.6. Checking IP settings

- Pick up the handset and dial ***
Check IP address :
- dial 02 to hear IP address.
Consult the number of the phone :
- dial 08 to hear its phone number.
Check subnet mask IP address:
- dial 03 to hear subnet mask IP address.
Check Gateway IP address :
- dial 04 to hear gateway IP address.
press '9' to select the priority voice codec.
press '9' to toggle between enable and disable.
message, enter 12 firmware server IP address digits
message, enter 12 firmware server IP address digits
press '9' to toggle between TFTP and HTTP.
press '9' to toggle between 'Always check', 'Check when
press '9' to reboot the phone. Or enter MAC address to
35