Monogram ZJ7000 Manuel De L'utilisateur page 7

Control
The warming drawer controls are hidden with
the drawer shut . Open the drawer . The controls
Knob
are on the right side of the front frame .
To use the warming drawer, press the ON/
OFF switch to the ON position .
Slide the moisture selector control to the open
or closed setting . (See the Moisture Selector
section .)
Turn the control knob clockwise to the desired
setting .
ON Signal The ON signal light is located below the ON/
OFF switch and glows when the ON/OFF
Light
switch is in the ON position . It stays on until the
ON/OFF switch is moved to the OFF position .
Moisture
The moisture selector is located on the inside
front of the drawer .
Selector
To keep foods moist, slide the moisture
selector control away from the control knob .
This closes the vent and seals the moisture
inside the drawer . With the vent closed hot
foods stay moist and soft .
In this setting condensation may occur around
the inside edge of the drawer .
To keep foods crisp, slide the moisture
selector control to the right towards the control
knob . This opens the vents and allows the
moisture to escape .
With the vents open, it is normal for moisture
to collect on surfaces above the warming
drawer .
49-80384-6
PROOF . . . 75–95°F .
LOW . . . . . 140–160°F .
Using the Warming Drawer
MED . . . . . 160–195°F .
HIGH . . . . 195–230°F .
The ON signal light is visible through the light
viewer in the drawer front panel when the
drawer is closed . This is a reminder that the
heat is on .
Electric Warming Drawer
7