Startup Procedure - Metz Connect KAPRi plus Instructions De Service

5. Startup Procedure

Before operation put in the 9 V block battery first.
1. Unscrew the two screws on the bottom of the unit and take this
part away. You will find the battery case with the connector clip
for the battery.
2. Press the clip on to the battery and put the battery into the
battery case. Should the battery be contacted with the wrong
polarity the KAPRi plus will not be damaged.
3. Close the lid and fasten the screws.
Now the installation tester KAPRi plus is ready for use!
E6