Maintenance - Dovre 350CB Installation Et Mode D'emploi

5.

Maintenance

It takes little effort to keep your stove in good condition.
Regularly check whether the sealing cord still closes the doors tightly enough.
The painted or enamelled cast iron mantle can be cleaned with a moist, soft cloth,
when it is almost cold. Make sure no aggressive, acid products get in touch with
enamelled parts.
Minor paint damage can be touched up with a can of spray paint. Your dealer can
supply you with the correct spray product. For enamel damage, small repair kits of
appropriate colour are available from your dealer.
During the first use after repainting your unit might give off some slight odour.
However, this will disappear quickly.
The glass can be cleaned with a number of glass cleaning products available from
your dealer. Your installer can also supply you with appropriate products. However,
never use abrasive or corrosive cleaning products.
A tight upper air slide can be adjusted with the two screws
just above the air intake holes on the front plate (see
sketch).
At the end of the heating season, seal off the chimney with a ball of paper. You can
then thoroughly clean the stove on the inside. If necessary, replace the sealing ropes
and use fire cement to fill up possible leaks. Remove the fire plate for better and
more thorough cleaning. The fire plate is fixed onto the back plate of the stove with
one bolt, visible from the outside. After having removed this bolt, you can easily
take the fire plate out of the stove. Eventually remove the refractory stones first.
You should have your chimney swept by an expert before the heating season begins.
It is also useful to check the chimney for soot during the heating season and to
check for blockage of the chimney flue prior to re-lighting after a prolonged shut
down period. Checking and maintaining the chimney is a statutory requirement.
When all of the above advice is heeded, you will be able to fully enjoy your stove.
30
350CB - 360CB - 350CB/SC 350CB/3 - 360CB/3 03.27898.100