Remplacement Gratuit Des Étiquettes - DeWalt DXCMWA5591056 Guide D'utilisation

GLOSSARY
CFM: Cubic feet per minute.
SCFM: Standard cubic feet per minute; a unit of measure of air
delivery.
PSI: Pounds per square inch; a unit of measure of pressure.
Code Certification: Products that bear one or more of the fol-
lowing marks: UL *, CUL, ETL *, CETL, have been evaluated by
® ®
OSHA certified independent safety laboratories and meet the
applicable Standards for Safety.
* UL is a registered trademark of Underwriters Laboratories and
®
ETL is a registered trademark of Electrical Testing Laboratories.
®
California Code: Unit may comply with California Code 462 (l)
(2)/(M) (2). Specification/model label is on the side of the air tank
on units that comply with California Code.
Unloader Blow-Off Pressure: All models are continuous running
units controlled by air tank pressure. When the maximum air
tank pressure is obtained, the unloader valve will blow-off. This
will cause the compressor to exhaust the air to the atmosphere
and not the tank. This decreases the load on the engine and
allows it to run at a near no-load condition.
Unloader Reset Pressure: When the air tank pressure drops to
a predetermined point, the unloader valve closes. The air tank
pressure will now increase until it reaches the unloader blow-off
pressure.
REMPLACEMENT GRATUIT DES ÉTIQUETTES
D'AVERTISSEMENT : si les étiquettes d'avertissement
deviennent illisibles ou sont manquantes, composer le 1-888-
895-4549 pour en obtenir le remplacement gratuit.
60