Power Bank Function; Charging The Battery; Changing The Battery; Technical Data - brennenstuhl BLUMO 2000 A Mode D'emploi

Operating instructions
D
BATTERY STATUS INDICATOR (C)
Indicates the current battery charge when the light is switched on. If all 4 LEDs are lit, the battery
is fully charged. If the battery is almost empty, the LED light flashes 5 times and the battery status
indicator flashes continuously. Afterwards, the light remains on for 5-10 minutes with reduced
brightness before it is switched off by the deep discharge protection function. This ensures suffi-
cient time to change the battery or complete work.

Power bank function:

This function enables charging of devices via USB cable with a charging current of up to 2000 mA
(e.g. smartphones). To charge the target device, connect it with an USB charging cable to the USB
charging port (D) under the transparent cover cap on the back of the device. After charging, reat-
tach the cover cap.

CHARGING THE BATTERY

To ensure optimum function, we recommend fully discharging the integrated battery on the first
use and fully charging it afterwards.
The charging port (E) is located under the transparent cover cap on the back of the device. Con-
nect the charging port to the provided power supply unit and plug the power supply unit into a
power socket.
The battery can also be charged with the provided vehicle charging cable (G).
The charging status of the battery is indicated by the battery status indicator (see description
above). If all 4 LEDs are lit, the battery is fully charged.
The light can be used during the charging process. However, it is automatically set to 50 % bright-
ness and the charging duration of the battery is extended.
If the device is not used for longer periods of time, charge the battery at regular intervals of approx.
3 months to ensure a long service life.
After charging, always close the charging port with the cover cap.

Changing the battery:

Removal: Press the unlocking buttons with the middle finger and thumb and pull out the battery.
Insertion: Align the electrical connections of the battery and press it in. If the battery is inserted
correctly, it clicks into place.

TECHNICAL DATA

LEDs:
Luminous flux:
Dimming:
Rechargeable battery:
Operating time:
With speaker:
Charging duration:
Charging input:
Power bank:
Power bank charging duration:
Nominal power of speaker:
Frequency band:
Operating frequency:
Max. transmitting power:
8
18P104 0497195 Mobiler Slim LED Blumo 2000A 180920.indd 8
40 x SMD Everlight
2100 lm
100/50/10 % light
Li-Ion 5x 3.7 V/2.2 Ah = 40.7 Wh
3/6/15 h (100/50/10 %)
3/6/12 h (100/50/10 %)
4.5 h
12 V DC/1.0 A
USB 5 V/2 A
~3.0 h (at 2 A)
2 x 3 W
2.4 GHz
2402 MHz – 2480 MHz
0 dBm
20.09.2018 15:56:11