Installing A Sam On Its Support; Removing A Sam - Sagem Monetel EFTsmart Notice D'installation

5.2 OPENING THE SECONDARY READER COVER FLAP
Precaution to be taken prior to opening the cover flap : Disconnect the power supply unit.
To open the SAM support cover flap:
•
Turn the terminal round to gain access to the
flap.
•
Using a fingernail, unclip the flap and pull in the
direction of the arrow (see figure opposite) to
remove it.

5.3 INSTALLING A SAM ON ITS SUPPORT

To install a SAM on its support:
•
First determine the location of SAM supports
• Slide the SAM into its housing so that the cut edge
of the SAM coincides with the cut edge of the SAM
support.
Note : According to the product type, the number of
SAM supports might be different.

5.4 REMOVING A SAM

Precaution : Take care not to bend or twist the SAM when withdrawing it according to the procedure below.
To remove a SAM:
•
Identify the number of the SAM to be removed
(see the numbers engraved beside).
Delicately withdraw the SAM, taking care not to bend
it.
Handy tip: use a piece of adhesive tape as shown
opposite to make withdrawal easier.
page 28 / 40
INSTALLATION MANUAL
SAM module
3300039745 R11 000 04/735