•
Back massage
Massaging the back by means of the massage hose without the assistance of another person is very difficult.
Therefore, use the special nozzle for back massage; you attach this to the jet nozzle in the same way as you
attach the massage hose. Position yourself with your back to the nozzle. The shorter the distance between the
nozzle and your back, the stronger the massage.
•
Before massage, you must definitely reduce the jet pressure.
•
Surface massage
Reduce the jet to half strength. Simply position yourself directly in front of the nozzle. The broad pressure-jet
powerfully massages your skin, the tissue beneath it, and your muscles. This promotes the circulation of the
blood, loosens you up and relaxes you.
4.6 Swimming against the Current
Select maximum flow and the jet direction so that the layer of water just under the surface is made to flow
strongly, without excessive effervescence being visible on the water surface.
4.7 Winterization
If the unit is installed in a pool where there is a danger of frost, the water level has to be reduced to the lowest
point of the front plate. Close the valve on the suction side, then unscrew the discharging screw at the undersi-
de of the pump.
Do not screw the discharging screw in again after having emptied the pump.
Warning
4.8 Again- operation
Before putting into operation again, screw in the discharging screw, open valves and fill the pool. Before switching
on, rotate the pump by hand several times at the ventillating fan in the direction shown.
5 SERVICE
Operate the unit only in perfect condition. Take care to have it regularly checked and seviced.
When repairing or bringing into operation again, ensure that tampering has not occured.
The unit is only to be serviced by authorized persons. Do not conduct any work which might
Warning
have impair on the safety of the unit. Only buy original spares from your dealer or uwe.
24