Cameo Flat Pro Spotix CLFLATPROSP4 Manuel D'utilisation page 17

MACRO 08
MACRO 09 Lavender
MACRO 10 Mauve
MACRO 11 Magenta
MACRO 12
MACRO 13 Warm White
MACRO 14 White
MACRO 15 Cold White
INTERNAL PROGRAMS
Press the MODE button repeatedly until the desired internal program appears on the display.
Internal programs CLFLATPROSP4
JUMPING All pixels are identical: Colours alternate
rapidly
Meteor Pixel Control Sequence
FADING All pixels are identical: The colours blend into
each other.
Flow Pixel Control Sequence
Single Single Pixel Sequence
Dual 1 Dual Pixel Sequence 1
Dual 2 Dual Pixel Sequence 2
Dual 3 Dual Pixel Sequence 3
Dual 4 Dual Pixel Sequence 4
Random Random Pixel Sequence
Colour Quad Pixel Sequence
AUTO Combining several programs
The internal programs can be adjusted separately for speed and stroboscope frequency. Press ENTER to move the cursor to the "SPEED: xx" field
in the bottom line. Using the UP and DOWN buttons, the speed of the program can be set (SPEED:00 = slowest speed, SPEED:99 = fastest speed).
Pressing the ENTER button again confirms the input and moves the cursor to the "FLASH:xx" field. Using the UP and DOWN buttons, you can activate
the strobe effect and adjust the strobe frequency from 00 to 99 (FLASH:00 = strobe effect deactivated, FLASH:01 = approx. 1 Hz, FLASH:99 =
approx. 20 Hz). Confirm with ENTER.
For example:
SLAVE MODE
Press the MODE button repeatedly until "SLAVE MODE" appears on the display. Connect the slave and the master unit (same series) with a DMX
cable. Enable one of the standalone modes in the master unit. Now the slave unit follows the master unit.
MUSIC CONTROL (SOUND)
Press the MODE button until "SOUND" appears in the upper line of the display. Now the spotlight is controlled by the built-in microphone and
follows the beat of the music (bass pulses). To adjust the microphone sensitivity, press ENTER, and the cursor appears in the lower line of the
display (SENS:xx) and use the UP and DOWN buttons to set the desired value from 00 to 99 (SENS:00 = minimum sensitivity, SENS:99 = maximum
sensitivity). Confirm with ENTER.
SELECTING DMX MODE
Press the MODE button repeatedly until "DMX MODE" appears in the upper line of the display. Press ENTER, and the cursor appears in the lower line
of the display and then use the UP and DOWN buttons to select one of the six DMX modes (02CH, 03CH1, 03CH2, 09CH, 18CH/27CH). Confirm with
ENTER. You will find tables with the channels of the different DMX modes on the following pages of this manual.
Blue
Pink
Internal programs CLFLATPROSP7
JUMPING All pixels are identical: Colours alternate
rapidly
Meteor Pixel Control Sequence
FADING All pixels are identical: The colours blend into
each other.
Flow Pixel Control Sequence
Single Single Pixel Sequence
Dual 1 Dual Pixel Sequence 1
Dual 2 Dual Pixel Sequence 2
Three 1 Tri Pixel Sequence 1
Three 2 Tri Pixel Sequence 1
Random Random Pixel Sequence
Colour Hepta Pixel Sequence
AUTO Combining several programs
17