Warranty Service; Warranty & Service - Airxcel ROUGHNECK Série Mode D'emploi Et Utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

If the air conditioner continues to trip the circuit
breaker, have an electrician check the starting
amperage and running amperage on the unit. If
the circuit breaker continues to trip off and the
electrical consumption is found to be normal, it
will require the replacement of the faulty circuit
breaker.
If all electrical power to the air conditioner is normal
but neither the fan or the compressor will operate,
the connector plug located behind the ceiling
assembly control box should be checked to determine
whether it is faulty.
On the heating-cooling air conditioner models, if all
electrical power to the unit is normal and the fan runs
but you never get any heated air, then the electrical
plug to the heating unit should be checked for a
secure connection. If this does not correct the
malfunction, the heating thermostat or limit switch
may be faulty.
Let's face it. Sometimes even the best products may need
service. To obtain warranty service on your Coleman-Mach
air conditioner, please contact your selling dealer, or you may
access our web site on the Internet at
answers to the most frequently asked questions and service
center locations.
Airxcel, Inc.
RV Products Division
P.O. Box 4020
Wichita, KS 67204
Carefully read your limited two year product warranty which
is packed with the product.
V. WARRANTY SERVICE
www.rvcomfort.com
for
C.
Mechanical Integrity - The air conditioner should
be inspected periodically to be sure the bolts which
secure the unit to the roof are tight and in good shape.
Also, an examination of the plastic shroud covering
the air conditioner on top of the roof should be made
periodically. Be sure the four screws are snug and
holding the shroud to the air conditioner. While
examining the tightness of these screws, also
examine the shroud to be sure it has not suffered
damage from impact.
D.
Lubrication -
DISCONNECT THE POWER SUPPLY TO
THE UNIT BEFORE SERVICING TO
PREVENT A SHOCK HAZARD OR
POSSIBLE INJURY FROM MOVING PARTS.
Inquiries to your Airxcel, Inc. representative and Airxcel, Inc.
on this unit should contain the model number and serial
number. The model number and serial number can be found
on the I.D. label located at the bottom of the roof unit. Access
to this label is accomplished by lowering the ceiling plate
(same procedure as used for filter service).
A model and serial number may also be found on the rating
plate fastened to the condenser coil, which can be seen by
looking through the louvers on the outside shroud.
Inquiries on the Ceiling Assembly should contain the ceiling
assembly part, serial or code date number. This information
can be found on the I.D. label.
6
DANGER

Publicité

Table des Matières
loading

Table des Matières