Care And Cleaning; Troubleshooting; Installation - AEG HE604000H Notice D'utilisation

6. CARE AND CLEANING

Clean the appliance after each use.
Always use cookware with clean bottom.
Scratches or dark stains on the
surface cause no effect on how
the appliance operates.
To remove the dirt:
1. Use the cleaning powder or the
cleaning pad.
2. Clean the appliance with a moist
cloth and some detergent.
3.
Heat the hotplate to a low tempera-
ture and let it to dry.
4. To keep the hotplates in good
shape, regularly rub in a sewing ma-
chine oil. Polish off the oil with ab-
sorbent paper.

7. TROUBLESHOOTING

You cannot activate the
appliance or operate it.
If you tried the above solutions and can-
not repair the problem, speak to your
dealer or the customer service. Give the
data from the rating plate, three digit
letter code for the glass ceramic (it is in
the corner of the glass surface) and an
error message that comes on.

8. INSTALLATION

WARNING!
Refer to the Safety chapters.
Before the installation
Problem
The stainless steel can become dirty if
the temperature is too high. Because of
this do not cook with the stone pots,
earthenware pans or cast iron plates. Do
not use the aluminium foil to prevent
damage to the top during operation.
The Stainless steel parts wash with water,
and then dry with a soft cloth.
Possible cause
Problem with the house
electrical system.
Make sure, you operated the appliance
correctly. If not the servicing by a cus-
tomer service technician or dealer will
not be free of charge, also during the
warranty period. The instructions about
the customer service and conditions of
guarantee are in the guarantee booklet.
Before the installation of the appliance,
record the information below from the
rating plate. The rating plate is on the
bottom of the appliance casing.
• Model ...........................
ENGLISH
For stainless steel edges of the
hob use the cleaning agent for
stainless steel.
The stainless steel edge of the
plate can change the colour as a
result of the high temperature.
Remedy
Activate the appliance
again and set the heat
setting in less than 10
seconds.
Examine the fuse in the
electrical system of the
house in the fuse box. If
the fuses blow again and
again, speak to qualified
electrician.
15