DeLonghi HFX65V15CA Mode D'emploi page 16

NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in
a particular installation. lf this equipment does cause
harmful interference to radio or television reception, which
can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by
one or more of the following measures:
- Reorient or relocate the receiving antenna.
TROUBLESHOOTING
PROBLEM
PF display
Product doesn't turn on
A green dot is flashing and unit
is off
The display shows "Ht" blinking
CAUSE
Temperature sensor is not working
properly
Check that the plug is connected
to the outlet
Auto-start is on
Room temperature reaches the set
temperature
The tip-over switch has been ac-
tivated
The internal temperature is too
high. The air intake or outlet grill
is obstructed
16
- Increase the separation between the equipment and
receiver.
- Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV
technician for help. Modifications not approved by
the party responsible for compliance could void user's
authority to operate the equipment.
CAN ICES-3 (B) / NMB-3 (B)
The product needs to be serviced, contact our toll
free number for assistance
Plug in
Wait till time elapsed or press the button (E) twi-
ce to cancel the auto-start and push the button
(A)
Use the "+" button to increase the set tempera-
ture
Make sure the appliance is standing upright on
a flat surface. If the problem persists contact our
toll free number to assist you
Check the appliance is correctly positioned
respecting the minimum distances from the
wall, or objects, as indicated on the instruction
manual. If not, position the appliance correctly
Remove the obstruction
Disconnect the plug from the outlet and let the
appliance cool down. After few minutes plug the
appliance in again. If the appliance doesn't work,
please contact the De longhi toll free number
SOLUTION