Please note:
This symbol indicates recommendations and important
information for the user.
- If your appliance is equipped with a
polythene tape used as carry handle,
remove it before connecting appliance
to the outlet.
- Always use the appliance in an upright
position.
- To disconnect heater, turn controls to
off, then remove plug from outlet.
- Connect to properly polarized outlets
only.
- This heater is not intended for use with
an extension cord or outlet strip. Plug
the cord directly into an appropriate
wall receptable.
- Check that neither the appliance nor
the power cable have been damaged
in any way during transportation.
- Make sure that no pieces of polystyrene
or other packaging material have
been left on the appliance. It may be
necessary to pass over the appliance
with a vacuum cleaner.
- When switching on the appliance for
the first time, allow it to run at full
power for at least two hours to get
rid of the unpleasant smell. Make
sure that the room in which the
appliance is located is well ventilated
during this operation. It is normal for
the appliance to emit small cracking
sounds when you turn it on.
- Do not use the appliance in rooms
with a floor area of less than 4mq (43
square feet).
- Before putting the appliance away,
make sure it is completely off and
unplugged from the outlet. Wrap the
cable around the base.
Do not store in dusty atmospheres.
- Do not rest anything on the appliance.
- Do not obstruct the air intake and
outlet grilles (danger of overheating).
- Do not place the heater near a bed
because objects such as pillows or
blankets can fall off the bed and be
ignited by the heater.
- This appliance is not intended for use
at altitudes exceeding 2000 m (6561
feet).
- A tip over safety device turns the
appliance off if it falls over or is
positioned inappropriately in such
a way as to jeopardize safety. The
appliance emits a beep and a dot
flashes on the display. The appliance
resumes operation a few seconds after
being placed in an upright position
again. See troubleshooting session.
SAVE THESE
INSTRUCTIONS
THIS PRODUCT IS FOR HOUSEHOLD USE
ONLY
DESCRIPTION
A
ON/STAND-BY button
B
+/- Adjustment buttons
C
Oscillation button
D
"ECO PLUS" function button
E
Timer button
F
MODE button (for selecting the operating mode)
G
Power indicator light
H
Back cover with filter
I
Receiver for remote control
USE
Installation
The appliance can be used on any horizontal surface.
Do not overload the electrical circuit. Avoid using the same
socket for other appliances.
13