DeLonghi HFX65V15CA Mode D'emploi page 12

whenever the heater is left operating
and unattended.
- Always disconnect the plug from the
power outlet when the appliance is
not in use.
- Do not wrap the cord around the appli-
ance immediately after use.
- The internal parts of the appliance can
become very hot or produce sparks
during operation. Do not use the
appliance in areas where gasoline,
paints, or other flammable liquids are
used or stored.
- Use this heater only as described
in this manual. Any other use not
recommended by the manufacturer
may cause fire, electric shock, or injury
to persons.
- To prevent overload and blown fuses, be
sure that no other appliance is plugged
into the same outlet (receptacle) or
into another outlet (receptacle) wired
into the same circuit.
- Make sure that the plug is fully inserted
into the outlet.
Wall outlets may deteriorate with
time, so check the plug periodically for
signs of overheating or deformation. If
the outlet has deteriorated, stop using
it and have it repaired.
- Do not use the appliance in small
rooms when they are occupied by
persons that are not capable of leaving
the room, unless constant supervision
is provided.
Danger of burns!!
Failure to observe the warning could result in burns or scalds.
- WARNING:
overheating,
any circumstances cover the
To avoid
never under
appliance during operation as this
would lead to a dangerous rise in
temperature, and risk of fire.
- Do not use the appliance on soft
surfaces, such as beds, where the
openings may become blocked.
- This heater is hot when in use. To
prevent burns, do not let bare skin
touch hot surfaces. Use handle when
moving this heater. To prevent burns,
do not touch hot surfaces with bare
skin. Use the handle when moving
the appliance. Keep all flammable
materials, such as furniture, pillows,
bedding, paper, clothing, and curtains
at least 90 cm (3 feet) from the front
and top of the appliance also avoid
contact with the sides and back.
- Do not run cord under carpeting.
Do not cover cord with throw rugs,
runners, or the like. Arrange cord away
from traffic area and where it will not
be tripped over.
- It is normal for the heater's plug and
cord to feel warm to the touch. A
plug or cord which becomes hot tothe
touch or becomes distorted in shape
may be a result of a worn electrical
outlet. Worn outlets or receptacles
should be replaced prior to further use
of the heater. Plugging heater into a
worn outlet /receptacle/ may result in
overheating of the power cord or fire.
- WARNING: Do not cover the appliance
while it is functioning in order to avoid
overheating which may cause risk of
fire.
Symbol meaning
This simbol indicates:
(If provided) Class II equipment
12