Care And Cleaning - Sharp SJ-FS810V Mode D'emploi

CARE AND CLEANING

WARNING
■ Unplug the refrigerator fi rst to prevent electric shock.
■ Do not splash water directly on the outer cabinet or the
interior. This may lead to rusting and deterioration of the
electrical insulation.
IMPORTANT
To prevent cracking on inside surfaces and plastic
components, follow these tips.
• Wipe any food oils adhered to plastic components.
• Some household chemicals may cause damage, so use only
diluted washing-up liquid (soapy water).
• If undiluted detergent is used or soapy water is not wiped off
thoroughly, cracking of plastic parts can result.
1
Remove the water tank and clean and dry it thoroughly to
prevent water stain or bacteria from being attached. (Once
a week)
2
Remove the accessories e.g. shelves from the cabinet and
door. Wash them in warm soapy dishwashing water; rinse
in clean water and dry.
3
Clean the inside with a cloth soaked in warm soapy
dishwashing water. Then, use cold water to wipe off soapy
water.
4
Wipe the exterior with a soft cloth each time it is soiled.
5
Clean the Magnetic door seal with a toothbrush and warm
soapy dishwashing water.
6
Wipe the control panel with the dry cloth.
NOTE
• To prevent damage to your refrigerator, do not use heavy duty
cleansers or solvents (lacquer, paint, polishing powder, benzine,
boiled water, etc.).
• If the power supply is disconnected, please wait for at least
5 minutes before re-connecting power.
• The glass shelves weigh approximately 3 kg each. Hold fi rmly
when removing from the cabinet or carrying.
• Do not drop objects inside the refrigerator or strike the inner wall.
This may cause the inner surface to crack.
18
Defrosting
Defrosting is fully automatic due to a unique energy saving
system.
When the compartment light is blown
Contact the service agent approved by SHARP to request a
replacement compartment light. The compartment light is not to
be removed other than by qualifi ed service personnel.
When transporting
• Before transporting, empty the ice tray by the following
procedure.
1
Empty the water tank and the ice storage box.
2
Set Ice tray cleaning mode "ON".
(Refer to "Ice tray cleaning".)
3
About 40sec. later, empty water or ice of ice storage box
when you hear the ending sound.
• Wipe up water in the evaporating pan. Before wiping up the
water, wait more than 1 hour after pulling out the plug because
refrigeration cycle equipment is extremely hot.
(The evaporating pan is located on the rear of the product.)
• The casters allow the refrigerator to
move back and forth.
• Carry the refrigerator by holding the handles located on the
rear and bottom.
Switching off your refrigerator
If you switch your refrigerator off when you are going away
for an extended period, remove all food, clean the interior
thoroughly. Remove the power cord plug from the power socket
and leave all doors open.
Evaporating pan
Casters