Refco REFMATE Manuel D'utilisation page 6

Bedienungsanleitung REFMATE
The manifold must not be used for pressures higher than

60 bar / 870 psi / 6000 kPa / 6 MPa.

Under no circumstances should the manifold be used as a
pressure reducing valve, especially when nitrogen N
The manifold must not be used with the refrigerant ammonia

(NH
The manifold must not be exposed to rain or used in damp or

wet environments.

Always wear protective goggles and gloves when working with
the manifold.
REFCO products have been specially designed and
manufactured for use by trained refrigeration technicians. Due

to the high pressures and chemical and physical gases used in
refrigeration systems, REFCO disclaims all responsibility and
liability for accidents, injuries and death.

REFCO expressly points out that the products should only be
used by professionally trained specialists.
Intended use
The manifold has been developed for measuring and regulating the pressure
and temperature conditions in mobile and stationary refrigeration systems
and heat pumps as well. Only trained refrigeration technicians are permitted
to use this REFCO product.
5
/ R717) and not in EX zones.
3
Deutsch
is used.
2