Aiwa AV-S17 Mode D'emploi page 7

CONNECTING THE SUPPLIED ANTENNAS 2
Connect the FM antenna to the FM 75 Ω terminals and the AM
antenna to the AM LOOP terminals.
To stand the AM loop antenna on a surface
Fix the claw to the slot as shown in the illustration.
To position the antennas
FM feeder antenna:
Extend this antenna horizontally in a T shape and fix its ends to
the wall.
AM loop antenna:
Position for the best reception.
NOTE
• Do not bring the FM antenna near metal objects or curtain rails.
• Do not bring the AM antenna near other external equipment,
the unit itself, the AC power cord or speaker cords, as noise
will be picked up.
• Do not unwind the AM loop antenna wire.
CONNECTING AN OUTDOOR ANTENNA
For better FM reception, use of an outdoor antenna is
recommended. Connect the outdoor antenna to the FM 75 Ω
terminals.
5
ENGLISH
FM antenna
AM antenna
ABOUT THE REMOTE CONTROL
Inserting batteries
Detach the battery cover on the rear of the remote control and
insert two R6 (size AA) batteries.
When to replace the batteries
The maximum operational distance between the remote control
and the sensor on the unit should be approximately 5 meters
(16 feet). When this distance decreases, replace the batteries
with new ones.
Using the remote control
The instructions in this manual refer mainly to the buttons on the
main unit.
Some buttons have two functions.
• To use the function indicated on the button, or on the plate in
black, simply press the button.
• To use the function indicated on the plate in green, press the
button while pressing the SHIFT button.
Important
• The ENTER button on the remote control does not
substitute for the ENTER button on the main unit. This
button is for operating the DVD player only (see the next
page.)
• In principal, the TUNING UP and DOWN buttons on the
remote control substitute for N (TUNING UP) and M
(TUNING DOWN) buttons on the main unit.
To select the function (audio source) with the remote
control
Press the FUNCTION button repeatedly. The function changes
cyclically.
NOTE
• If the unit is not going to be used for an extended period of
time, remove the batteries to prevent possible electrolyte
leakage.
• The remote control may not operate correctly when:
- The line of sight between the remote control and the remote
sensor in the display window is exposed to intense light, such
as direct sunlight.
- Other remote controls are used nearby (those of a television,
etc.)