Recording An Audio Source - Aiwa AV-S17 Mode D'emploi

About the video source to the monitor or TV
Selected Video source
V1: VIDEO 1, V2: VIDEO 2, V3: VIDEO 3
The selected video source is indicated on the display and the
video signal through the MONITOR VIDEO OUT jack is output
on the TV.
To select the video source
1 Turn the FUNCTION to select PHONO, CD or AUX.
2 Press the ENTER button to display VIDEO 1.
3 Turn the MULTI JOG to select VIDEO 2 or VIDEO 3.
To change a displayed name for the VIDEO 1
and VIDEO 2
When the VIDEO 1 function is selected, VIDEO 1 is displayed
initially. It can be changed to DVD or MD.
Press the BAND button while pressing the ENTER button, then
release the ENTER button first.
The displayed name for the VIDEO 2 function can be changed
to VIDEO 2, LD or TV; while the VIDEO 2 function is selected,
press the BAND button while pressing the ENTER button, then
release the ENTER button first.
To adjust the sound level of the connected
source
The input sensitivity level of each function can be adjusted (except
the TUNER and TAPE MONITOR).
When the sound level of the connected source is higher or lower
than that of the TUNER, adjust it as follows.
1 Select the function to be adjusted.
Turn the FUNCTION and play the source.
2 Press the N (UP) or M (DOWN) button
repeatedly.
The level can be adjusted between -6dB (MIN) and +8dB
(MAX) in 2dB steps. Adjust the level so that the sound is output
at the same level as the TUNER.
NOTE
The input sensitivity level of the TAPE MONITOR cannot
be adjusted. Even if TAPE MONITOR is selected,
pressing the N orM button will change the level of the
selected function (except TUNER) displayed on the
window.

RECORDING AN AUDIO SOURCE

1 Select the program source to be recorded.
Turn the FUNCTION.
2 Set the tape deck or MD recorder to the recording
mode.
3 Start the selected program source.
To monitor recorded sound during recording (when the
connected tape deck is a three-head system)
Press the TAPE MONITOR button. "TAPE ON" appears on the
display for four seconds, and then the source name selected in
step 1 comes back on. To cancel the tape monitor, press it again
so that "TAPE OFF" appears.
NOTE
• Any sound control system has no effect on recording (see
page 8).
• When recording audio sources by the MD recorder connected
to the VIDEO 1/DVD/MD AUDIO OUT terminals, the selected
video source (see left column) should be V2 or V3. Recording
cannot be done while the V1 (VIDEO 1) is selected and
displayed on the window.
• Input sound from the tape deck connected to the TAPE
MONITOR IN terminals cannot be recorded.
En En En En En
E E E E E
(Españo (Españo
(Españo (Españo (Españo
F F F F F
(França (França
(França (França (França
10
ENGLISH