Maintenance - Vacmaster VOC507S Manuel D'utilisation

1
EMPTYING THE COLLECTION TANK
WARNING:
BEFORE REMOVING THE POWER HEAD FROM COLLECTION TANK.
1. Verify that the power cord is disconnected from the outlet (Fig. 1).
2. Disconnect the hose from the vacuum (Fig. 2).
3. Undo the latches and remove the power head from the collection tank (Fig. 3). Place power
head on a soft, clean surface upside down.
4. Clear all dirt or debris from the collection tank and hose into a proper waste container (Fig. 4).
5. Clean or replace the filters.
6. Check the hose, attachments, and power cord to ensure that they have not been damaged.
7. Place the power head back onto the collection tank and secure latches.
IMPORTANT! Clean or change the filter regularly for best performance. ALWAYS USE THE
REUSABLE CLOTH FILTER FOR DRY VACUUMING. If the machine is used without the reusable
cloth filter, the motor will burn out and the warranty will be voided. Always keep spare filters on
hand.
NOTICE! The filters included are made of high-quality materials designed to stop small dust
particles. The reusable cloth filter should be used for dry pick-up only. A dry reusable cloth filter
is necessary to pick up dust. If the reusable cloth filter is wet, it will clog quickly and be difficult to
clean. Handle the filter carefully when removing it for cleaning and replacing it. Check the filters for
tears or small holes. A small hole can let dust pass through and out of the filter. Do not use a filter
with holes or tears; replace it immediately.
STORAGE
Before storing your vacuum, the collection tank should be emptied and cleaned. The accessories
should be cleaned and stored so they can be readily available when needed. Store the wet/dry
vacuum indoors.
REPAIRS
Repairs for this wet/dry vacuum should be performed only by qualified service personnel using
only identical replacement parts.

MAINTENANCE

2
ALWAYS DISCONNECT THE PLUG FROM THE POWER OUTLET
3
12
4