Installation - EuroLite Rubberlight LED RL1-230 Mode D'emploi

If this device will be operated in any way different to the one described in this manual, the product may suffer
damages and the guarantee becomes void. Furthermore, any other operation may lead to dangers like short-
circuit, burns, electric shock, etc.

INSTALLATION

Unpack the lighting chain.
Unroll the tube, connect it with the mains and wait some minutes until it has warmed up. Disconnect from
mains and start with the installation.
Only cut the tube where marked. The tube can be cut after every 72 LEDs (2 m distance).
The tube is water-proof (IP 44). Nevertheless, you have to insulate the connectors, the power-connector and
the end cap with some silicone for outdoor-use.
In order to design the desired patterns, draw the form onto the surface and attach the mounting-clips. For
free forms, you can use a stable wire in order to bring the tube into the desired form. Use tie straps in order
to connect the tube with the wire. You can fix the tie straps with the suction cups.
The minimum bending radius is 3 cm.
Bend the tube to the left side and cut off surplus wires. Bend the tube to the right side and cut off surplus
wires.
How to the connect the power-connector:
First attach the screw plug onto the tube. Attach the power-connector to the cable-ends then. Fix the screw
plug.
How to connect several tubes:
Disconnect from mains!
Make sure that you only connect 230 V-versions.
The maximum length must not exceed 44 m.
Make sure that you always connect the connectors in the right way. First attach the srew plug onto the tube.
Attach the connector onto the cable-ends then. Fix the screw plug. Connect the sockets with one another
and fix the srew plug. Connect the next tube like described above.
The last tube has to be terminated with an end cap. Please make sure that you stick the end cap at the tube.
How to connect the tube to the power supply:
Connect the power-connector to the mains. Make sure that the outlet is in a dry area.
How to connect a controller:
Connect the power cord with your controller.
After the installation, the power supply cable, the plug and the connector must be free of any tractive forces
and rotary forces.
The lighting chain must never be covered with any object.
DANGER TO LIFE!
The electric connection must only be carried out by a qualified electrician!
11/20 00027067.DOC, Version 1.5