Control Panel; Power Requirements - Hamilton Beach HBF400 Manuel D'utilisation

Control Panel

Timer Knob*
* 3 Min. Max

Power Requirements

Use a fused electric outlet for the blender. Depending on the model of your blender, the plug will look like
the following to meet power requirements:
120 VAC, 60Hz
Ground
prong
Blender Operation – Quick Start Guide
1. Read Important Safety Instructions and Warnings
before use.
Place the blender on a dry, level surface.
2.
3. Make sure the Power/Reset switch is set to
OFF (O), and the Standby/ON (I) switch is set to
STOP . Plug the blender into a grounded 3-
prong electrical outlet.
Place the container on the base with ingredients
4.
and container lid in place.
High
Speed
Low
Speed
Pulse
230 VAC, 50Hz
230 VAC, 50Hz
5. Turn the Power/Reset switch on the rear of the
base to the ON (I) position.
Select the desired speed: HIGH (2) or LOW (1).
6.
7. Adjust the timer knob to desired run time.
8. Set the Standby/ON (I) switch to START
use PULSE .
Start
Standby/ON (I)
Stop
or
5