Steba QH 1800 Mode D'emploi page 13

Installation
∙ We recommend to switch off the mains electricity supply before proceeding with
the following steps.
∙ Fix the wall bracket using it as a template to drill holes for the rawplugs. Mind that
the 3 holes which hang the unit should be in the position shown in #4, NOT upside
down.
∙ The unit can be oriented in 2 positions.
∙ Horizontally
∙ Downwards
∙ According to the orientation you prefer you have to fix the screws in position 1 if
you want the unit to be horizontal, position 2 if you want the unit to be inclined
downwards, as shown in #7.
∙ Remove the back plastic cover from the unit, as shown in #8.
∙ Remove the strain relief, as shown in #9 and feed the electric lead in from behind
through the round opening under the connection block and make connections
according to #9. Connect the 2 phases to the connection block. The blue wire to
the N pole, the brown wire to the L pole. L and N symbols are marked under the
connection block.
∙ Secure the supply powercord fixing the strain relief.
∙ Fix again in position the back plastic cover, as shown in #10.
∙ Hang the heater to the wall bracket and pull it down to securely fix it to the bracket
in the direction shown by the arrow, as in #11.
∙ Check that the unit is correctly fixed pulling it towards you; it shouldn't move.
Connection to the mains electricity supply
∙ This product has a double electrical insulation protection (class II) and therefore
does not require an earth connection.
∙ The appliance may only be connected to a 1/N/PE 230V AC 50 Hz supply. If the cord-
set is to be used we recommend to use a rubber coated one (type H05RR-F) with at
least a 2 x 1 mm2 section.
Operation
Pulling the switch the product gets in function. You can see from the front viewing
window the following symbols:
Product rating 0
230V 1800W OFF
I II
600W 1200W
III
1800W
13