Evolite ArchiTECH 150 BAT Mode D'emploi page 22

WORKING
ACTION
MODE
White
Red fast flash
W-DMX Blue fast flash
Receive
Blue slow
flash
Blue
Red fast flash
Blue fast flash
X-DMX
Blue slow
Transmit
flash
Blue
 Set 【Receive】mode, as shown in figure 1.
 Select【RESET】menu to reset wireless connection, as shown in figure 2. At this time, the indicator light is white, indicating
that the wireless module is not connected to transmit module and is ready to receive the paired signal.
 According to step 3.2.1 to set 【Transmit】mode, as shown in figure 3. At this time, the indicator light is blue slow flash,
indicating that the wireless module is not connected to DMX signal.
 Select【RESET】menu to reset wireless connection, as shown in figure 2. At this time, the indicator light is red fast flash,
indicating that deleting all receiver's connection.
 Select【CONNECT】to transmit wireless paired signal, at this time the indicator light is blue fast flash.

When the light's receiver receive the paired signal by transmitter, the indicator light is blue which means the connection is
established.
ArchiTECH 150 BAT Manual Ver. 1.00
STATUS DESCRIPTION
Connection is not established
Connection is lost
Connecting to transmitter
Connected. Without DMX signal
Connected. Receiving DMX signal
Deleting all receivers' connection
Connecting with the Receiver(s)
No DMX signal input
Transmitting DMX signal
Note: The wireless transceiver
remember the chosen
protocol even after you disconnecting the
power supply.
There is no need for repeated setting.
will
22
Page