Cleaning And Maintenance - Techfrost SG30 Mode D'emploi

4. CLEANING AND MAINTENANCE

IMPORTANT
4.1. ROUTINE OPERATIONS
Clean the inside of the appliance carefully with warm water and neutral soap. Rinse and dry thoroughly.
•
Check that the condensation water drain is free from obstructions: clean if necessary.
•
Check cleanliness and condition of the door gaskets.
•
Check the state of the power supply wire: it must not have any defects that could compromise
•
its insulation.
ATTENTION !
4.2. IDLE TIME
In the event of prolonged idle periods, clean the appliance in the way described
above. Leave the doors ajar so that air can circulate and undesirable smells are
avoided. Protect the compartment containing the control mechanisms from dust.
ATTENTION !
TECHFROST
ALWAYS MAKE SURE THAT THE APPLIANCE IS UNPLUGGED AT THE MAINS
BEFORE CARRYING OUT ANY CLEANING OR MAINTENANCE OPERATIONS
AVOID USING AGGRESSIVE DETERGENTS IN GENERAL.
DO NOT USE WIRE PADS, BRUSHES OR METAL SCRAPERS ON THE
DURING CLEANING AND/OR MAINTENANCE OPERATIONS, TAKE GREAT
CARE NOT TO DAMAGE THE COOLING FLUID CIRCUIT IN ANY WAY
STAINLESS STEEL PARTS
Pagina 24 di 47