Techfrost SG30 Mode D'emploi page 24

3.4.YY ADJUSTMENTS
DISPLAY OR CHANGE OF SETPOINT
To display or change the set temperature, just press and release the key
blinking, use the keys
range -2 ÷ 8°C NT and -25 ÷ -10°C LT).
OTHER SENSORS DISPLAY
To display the temperature of the evaporator and capacitor sensors, press the key
appears on the display. Use the keys
to display the corresponding temperature.
HACCP ALARM RESET
To cancel recorded alarms (HACCP), press the key
and to select the label "rLS"; press the key
149
the value . Press the key
HACCP LED will go out. If no alarm is stored on the device, the label "rLS" will not be displayed.
CLOCK SETTING
To set the clock, press the key
to select the label "rtc"; press the key
arrow keys to set the correct value. Then press
(month), "dd" (day), "hh" (time in the 24h mode), "nn" (minutes). Having set all the values, press the key
again and the relative clock LED will go out.
WARNING!
TECHFROST
and to set the temperature, which appears on the display
and
- - - -
again: " " will appear blinking on the display for 4 s and then the
and the first label appears on the display. Use the keys
and "yy" (year) appears on the display. Use the up and down
EXCEPT FOR THE "SET" PARAMETER VALUE, ALL THE OTHER VALUES
ARE FACTORY SET TO OBTAIN THE SPECIFIC PERFORMANCE FROM THE
APPLIANCE FOR WHICH IT HAS BEEN DESIGNED. THE MANUFACTURER
THEREFORE ACCEPTS NO RESPONSIBILITY OF ANY KIND WHATSOEVER
SHOULD THE APPLIANCE AND THE VALUES BE TAMPERED WITH.
to select the label "Pbr" or "Pb3"; then press the key
; the first label appears on the display. Use the keys
and using the up and down arrow keys set
again and repeat the same procedure to set "nn"
.
When the LED starts
(within the
;
the first label
and
Pagina 23 di 47