Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2. INSTALLATION
IMPORTANT
2.1. PRELIMINARIES
Remove the protective film from the outer surfaces.
Carefully clean the inside of the appliance with warm water and neutral soap, then rinse and dry thoroughly.
ATTENTION !
Place the appliance in its permanent position and adjust the feet so that it is perfectly aligned. Make sure
that minimum clearance is observed, to allow use and maintenance operations.
2.2. CHECKS
Check that there are no sources of heat in the close vicinity.
Check that the electricity supply available complies with the rating plate on the appliance, and especially
that the mains voltage is within a tolerance of +/-10% of the value required.
ATTENTION !
TECHFROST
THE MANUFACTURER DECLINES ALL RESPONSIBILITY IF INSTALLATION IS
NOT CARRIED OUT BY PROPERLY QUALIFIED PERSONNEL OR IF THE
INSTRUCTIONS IN THIS MANUAL ARE NOT OBSERVED
DO NOT WASH WITH DIRECT OR HIGH PRESSURE JETS OF WATER AS
THIS COULD CAUSE INFILTRATION WHICH COULD COMPROMISE PROPER
OPERATION OF THE APPLIANCE OR THE SAFETY SYSTEM
THE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR ANY DAMAGE
CAUSED BY FAILURE TO EARTH THE APPLIANCE
Pagina 18 di 47
Publicité
Table des Matières
