Assembly; Setting-Up And Connection - Bartscher SB 325 Mode D'emploi

5.2 Assembly

Preparing the device for operation
•
Unpack the device and remove packaging material.
•
Clean the removable parts of the device (screw conveyor, tower, cascade plate) in
warm water with a mild detergent. Rinse all the parts with clean water and dry them
thoroughly.
•
Clean the bowl with warm water and mild detergent, rinse with clean water and dry it
with a soft cloth.
•
Wipe the motor unit and the power cord with a soft damp cloth. Ensure that the power
plug is completely dry before you connect the device to the power supply.
Assembling the device
•
Install the conveyor screw on the motor unit.
•
In the next step put the tower on the conveyor screw and screw it firmly to a suitable
holder.
•
Attach the middle and then the top cascade plate with the crown to the tower.

5.3 Setting-up and connection

•
Place the device on a stable, level surface near a wall outlet.
•
Level the device by means of the nuts and the adjustable feet (3) by turning gently
the lock nuts clockwise to raise the feet and anti-clockwise to lower the feet.
•
Place the device on a secure surface, which supports the weight of the device and is
heat resistant.
•
Never place the device on the table edge as it may tilt or fall down.
•
Never place the device in wet or moist area.
•
Do not place the device near open fireplaces, electric ovens, heating stoves or other
heat sources.
- 28 -