Adjustment Elements; Adjusting The Working Angle; Adjusting The Working Width - Viking AHK 701 Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 17
● Loosen lock nuts (2) and loosen
bolts (1) by turning in an anti-clockwise
direction. Then tighten the lock nuts
again.
Recommended setting:
Observe a distance (A) of approx. 3 mm
between the bolts (1) and adapter (3) of
the tiller or adapter (4).

8. Adjustment elements

AHK 701

8.1 Adjusting the working angle

The working angle (B) of the ridger
is adjusted by tightening and
loosening adjustment screw (1).
Reducing the operating angle (B):
● Loosen both lock nuts (2). Loosen
locating screw (3). Loosen adjustment
screw (1) by turning in an anti-
clockwise direction. Then tighten
locating screw (3) by hand until the
ridger is secure, tighten both lock
nuts (2) again.
Increasing the operating angle (B):
● Loosen both lock nuts (2). Loosen
locating screw (3) and tighten
adjustment screw (1) by turning in a
clockwise direction. Then tighten
locating screw (3) by hand until the
ridger is secure, tighten both lock
nuts (2) again.

8.2 Adjusting the working width

The side wings (1) of the ridger can
be adjusted to change the working
width (C) of the ridger.
14
Adjusting the working width (C):
● Lift retainers (2) and fit in one of the
holes on wings (1).
9. Adjustment elements
AHK 702
9.1 Adjusting the working depth
The ridger can be installed higher or
lower on the tiller as required.
Adjusting the working depth:
● Loosen tommy screw (1) and set
ridger (2) to the required height. Then
10
tighten the tommy screw by hand until
the ridger is secure.
11
12
0478 906 9905 A - EN

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Ahk 702

Table des Matières