Alpine CDE-175BT Mode D'emploi page 42

To prevent external noise from entering
the audio system.
• Locate the unit and route the leads at least
10 cm away from the car harness.
• Keep the battery power leads as far away
from other leads as possible.
• Connect the ground lead securely to a bare
metal spot (remove any paint, dirt or grease
if necessary) of the car chassis.
• If you add an optional noise suppressor,
connect it as far away from the unit as
possible. Your Alpine dealer carries various
noise suppressors, contact them for further
information.
• Your Alpine dealer knows best about noise
prevention measures so consult your dealer
for further information.
42
-EN
Installing the microphone (CDE-175BT/
CDE-172BT/ UTE-73BT only)
To capture your voice during handsfree calling,
you need to install the microphone
Clip (not supplied)
Cautions
• It is extremely dangerous if the cord becomes
wound around the steering column or
gearshift. Be sure to keep it and other parts
from interfering with your driving operations.
• If airbags or any other shock-absorbing
equipment is in your car, contact the store
where you purchased this unit, or the car
dealer, before installation.
Note
Before attaching the double-sided tape
surface of the dashboard with a dry cloth.
.
, clean the