Getting Started; Detaching The Front Panel; Attaching The Front Panel; Resetting The Unit - Alpine CDE-175BT Mode D'emploi

Getting Started

To cancel the demonstration (DEMO)
display, see page 24.
For the connection/installation, see page
38.

Detaching the Front Panel

You can detach the front panel of this unit to
prevent theft.
1
Press and hold
turns off, press the front panel release
button , then pull the panel towards
you to remove.
Caution alarm
If you turn the ignition switch to the OFF position
without detaching the front panel, the caution
alarm will sound for a few seconds. The alarm will
only sound if the built-in amplifier is used.
Serial numbers (CDE-175BT only)
Make sure the serial numbers on the bottom of
the unit and the back of the front panel are
matched correctly. Otherwise you cannot make
BLUETOOTH pairing, connection and
disconnection by NFC.

Attaching the front panel

10
-EN
(Power) until the unit

Resetting the Unit

Before operating the unit for the first time, or
after replacing the car battery or changing
connections, you must reset the unit.
1
Press and Number button 6 for more
than 2 seconds.
Note
Resetting the unit will erase the clock setting and some
stored contents.

Setting the Clock

1
Press and hold
seconds, rotate the control dial to select
[GENERAL], then press it.
2
Rotate the control dial to select [CLOCK
ADJ], then press it.
The hour indication flashes.
3
Rotate the control dial to adjust the hour
and minute.
To move the digital indication, press
.
4
Press ENTER to set the hour and minute.
5
Press (back) twice.
The setup is complete.
To display the clock
Press VIEW.
/SETUP for at least 2
/