Installation; Appropriate Installation Location; Installing The Plastic Wedges - Beko RDNE500K21S Manuel D'utilisation

Installation

3
3.1. Appropriate
installation location
Contact an Authorized Service for the
installation of the product. In order to
prepare the product for use, refer the
information in the user manual and
ensure that electrical installation and
water installation are appropriate. If not,
call a qualified electrician and technician
to have any necessary arrangements
carried out.
WARNING:
B
not be held liable for damages that
may arise from procedures carried
out by unauthorized persons.
WARNING:
B
be plugged in during installation.
Otherwise, there is the risk of
death or serious injury!
WARNING:
of the room where the product
shall be place is so tight to prevent
A
passing of the product, remove
the door of the room and pass
the product through the door by
turning it to its side; if this does
not work, contact the authorized
service.
• Place the product on an even floor
surface to prevent jolts.
• Install the product at least 30 cm
away from heat sources such as hobs,
heater cores and stoves and at least 5
cm away from electrical ovens.
• Product must not be subjected to
direct sun light and kept in humid
places.
• Appropriate air ventilation must be
provided around your product in order
to achieve an efficient operation. If the
product is to be placed in a recess in
the wall, pay attention to leave at least
5 cm distance with the ceiling and side
walls.
Refrigerator / User Manual
Manufacturer shall
Product must not
If the door clearance
9/40 EN
• Do not install the product in places
where the temperature falls below
-5°C.
3.2. Installing the
plastic wedges
Plastic wedges supplied with the
product are used to create the distance
for the air circulation between the
product and the rear wall.
1. To install the wedges, remove the
screws on the product and use the
screws supplied together with the
wedges.
2. Insert the 2 plastic wedges onto the
rear ventilation cover as illustrated in
the figure.