PR2000, PR2500
8.3
Checking
!
WARNING!
Do not use the awning if any settings or maintenance work are
required.
If you discover any damage, please contact the service partner in
the respective country (see addresses on the back of the manual).
➤ Check the awning regularly for any imbalance and wear, as well as
damage to major parts.
➤ Check the awning regularly:
– Is the fabric free of damage?
– Are the arms and front panel free of damage with no signs of wear?
– Does the awning close properly?
8.4
Tightening the screws on the hinges
The screws on the hinges must be tightened up after being used for the first
time:
after the first holiday using the awning
after driving 20000 km or six months after the awning was mounted
(whichever occurs first)
The screws on the hinge also need to be checked during the routine vehicle
inspection.
Contact your service partner to tighten up the screws.
Instructions for servicing (fig. b, page 7)
A
NOTICE!
The awning arms must not bear any load. This is to prevent the
fastening torque of the screws from being distorted.
➤ Lift up the front panel slightly so that the hinge does not bear any load.
➤ Tighten the screws with 15 – 25 Nm.
EN
Cleaning and maintenance
17