Glass Pane; Disassembly Of Glass Pane In Door; Assembly Of Glass Pane In Door - Dik Geurts Instyle 800 Instructions D'installation

IN S TA LLA TION M A N U A L

9.4 Glass pane

• Avoid damage when removing/fitting the glass pane;
!Caution
• Avoid/remove fingerprints on the glass pane because these burn in.
Use the supplied pane window cleaner to remove fingerprints/dirt on the glass pane.
Tip!

9.4.1 Disassembly of glass pane in door

To remove the glass pane in the door follow the instructions below:
(For a Prostyle appliance: see Appendix 2, fig. 11. For an Instyle applianc: see Appendix 2, fig. 12).
Ø
Open the door.
Ø
Lift the door out by first sliding it upwards, then tilt it slightly forwards and allow it to lower.
Ø
Place the door on a flat surface.
Ø
Remove the nuts from the strips.
Ø
Remove the strips.
Ø
Lift the glass pane out. The pane seal is then also taken out.
• When replacing the glass pane always replace the seal in the door (= seal between the glass pane and the
Tip!
door).
• Check the door sealing cord and replace if necessary (see paragraph 9.3).

9.4.2 Assembly of glass pane in door

Assemble the glass pane in the door according to the steps described in paragraph 9.4.1 'Disassembly of glass
pane in door' but in reverse order.
(For a Prostyle appliance: see Appendix 2, fig. 11. For an Instyle applianc: see Appendix 2, fig. 12).
Assembly of the door is somewhat different.
!Caution
Proceed as for assembly of the door:
Ø
Bring the hole at the bottom of the hinging part of the door exactly below the lower pin.
Ø
Slide the door up. The pin slides into the lower hole.
Ø
Bring the hole at the top of the hinging part of the door exactly above the upper pin and allow the door to lower.
The pin slides into the upper hole.
Ø
The door is now assembled.
• Do not fasten the bolts too tight to avoid breaking off and/or stripping: overtightening will cause breakage.
!Caution
• Place the glass pane (including new pane seal) with the logo to the bottom right.
41