Getting Started P; Charging The Battery - BWT BC 30 Manuel D'utilisation

GETTING STARTED

Charging the battery

IMPORTANT NOTE: Fully charge the pool vacuum (about 6 hrs) before using
it for the first time.
WARNING!
Use only the original external adaptor and charging base provided.

Make sure the pool vacuum and the charging contact plates are clean

and dry before set-up and charging. (TIPS: Use a cotton bud to dry the
charging contact plates)
Charging must be done indoors, in a well-ventilated area away from

sunlight, children, heat, ignition sources, and with an ambient
temperature between 5˚C (41˚F) and 35˚C (95˚F).
Never use the external adaptor and charging base if any damage is

detected.
The charging contact plates are waterproof. However, remnants of

water on the contact plates could result in natural occurrence of stains
(a byproduct of chemical reaction between water and electric currents).
Otherwise, the stains can be removed by light scrubbing with a cotton
bud soaked with juice of lemon or vinegar.
Make sure that the pool vacuum is turned off prior to charging.

1. Place the unit on a flat surface. Make sure the pool vacuum is off by
turning the power ON/OFF switch to the OFF position prior to charging.
2. Align and slide the hook of the charging base onto the side notch at the
bottom of the main body until it stops. Make sure their contact plates are
properly in contact.
MAINTENANCE & CLEANING 7 2021/02 : A