Emptying The Filter P - BWT BC 30 Manuel D'utilisation

Do not operate this pool vacuum if there are people/pets present in the

water.
Make sure the pool vacuum is fully immersed in the pool before initiating

operation. The minimum water level required to operate the pool vacuum
must reach above the power ON/OFF switch of the pool vacuum when it
is held in a vertical position. Operating the pool vacuum when it is not
immersed correctly could damage the unit and void the warranty.
DO NOT use the pool vacuum without an intact filter cage in place. Using

your pool vacuum without an intact filter cage in place will VOID your
warranty.
DO NOT leave the pool vacuum in the water when it is not in use.

1) Bring your pool vacuum to the side of your pool / spa. Immerse the pool vacuum in
water and turn the power ON/OFF switch to the ON position to initiate operation.
CAUTION! Make sure the pool vacuum is always facing downwards when it is placed into
the pool. Otherwise it may bend the pole connector and damage it during the process.
2) To remove the pool vacuum from the pool / spa, lift the pool vacuum while pointing it
downwards in order to allow water to escape from the outlet valve. Water is going to
escape via the pole connector and draining holes inside the connector chamber on the
rear body.
CAUTION! Make sure the pool vacuum is always facing downwards when it is removed
from the pool. Otherwise, the pole connector may be bent and damage the pool vacuum
in the process.
3) Rinse the pool vacuum with fresh water after every use. DO NOT use any detergent.
EMPTYING THE FILTER
WARNING!
Using the pool vacuum without a filter cage in place will
VOID your warranty.
In order to maximize the cleaning efficiency, be sure to clean the filter cage before and
after each use.
CAUTION! If the pool vacuum is charging, disconnect the external adaptor from the power
source and detach the pool vacuum from the charging base. Make sure the pool vacuum
is OFF
 Emptying the filter cage
1. Place the pool vacuum on a stable surface.
Press the locking button until the locking hole on the clear canister is released. Slide
2.
the canister away until the notch on the bottom of canister opening is released from
the hook on the bottom of main body. Remove the filter cage from the main body.
MAINTENANCE & CLEANING 11 2021/02 : A