NOTE: Let the pool vacuum rest for 30 to 40 minutes before charging it again.
Set-Up Before Use
Telescopic pole connector assembly
Press down the side pins of the connector and insert it inside the main body. Turn the
connector in either direction until the pin is secured in the hole, as shown in the diagram.
Telescopic pole (not included) assembly
Note: a V-clip is installed inside the pole connector to secure the telescopic pole (not
included) in position. Slide the telescopic pole onto the pole connector. Press on the side
pins of the connector and slide the telescopic pole further down until the pins of the
connector are secured inside the holes of the pole.
To release the telescopic pole, press down the side pins simultaneously and pull out the
pole.
Suction head/corner nozzle assembly
Insert the suction head directly into the suction mouth of the pool vacuum until the side
tabs of the transparent canister clip in the side holes of the suction head.
MAINTENANCE & CLEANING
9
2021/02 : A