Maintenance & Storage P - BWT BC 30 Manuel D'utilisation

CAUTION! Replace the damaged filter cage immediately before the next operation.
3. Clean out the debris and rinse the filter cage with water. If brushing is deemed
necessary, use only a soft brush to clean the filter cage gently and carefully.
To re-install the canister, first align the notch of the canister with the hook on main body
and then press the canister onto main body. Make sure the locking hole on the clear
canister is secured with the locking button.
MAINTENANCE & STORAGE
NOTE:
1. Be sure to clean and dry the charging contact plates after every use to avoid the
forming of stains (byproduct of a natural chemical reaction between electric current
and water). Otherwise, the stains can be removed by light scrubbing with a cotton bud
soaked with juice of lemon or vinegar.
2. Battery discharges on its own during storage. Make sure to charge the pool vacuum
to about 30% to 50% of the battery capacity before it is stored.
3. You must re-charge the battery at least once every three months when it is not in use.
 Unplug the external adaptor from socket and then unplug the adapter jack from the
charging base.
 Detach accessories from the pool vacuum. If necessary, rinse the pool vacuum and
accessories with fresh water. DO NOT use detergent.
 Make sure to drain the water from the unit and pole connector.
 Use a damp cloth to clean and dry the pool vacuum and its accessories.
 Store them in a well-ventilated area away from the sunlight, children, heat, ignition
sources, and pool chemicals. Ambient temperature for storage should be 10˚C – 25˚C
(50˚F – 77˚F). NOTE: A higher temperature may reduce the battery life during storage.

WARNING!
- Never attempt in any way to disassemble the pool vacuum.
MAINTENANCE & CLEANING 12 2021/02 : A