GE Profile CustomStyle 22 Série Manuel D'utilisation Et D'installation page 15

Inserting the door panels.
Remove the Top Trim on the Freezer Door
Using a T-20 Torx Driver, remove the two screws attaching the Top Trim.
Remove the Side Trim
Using a Phillips screwdriver, remove the four screws attaching the Side Trim
to the refrigerator and freezer doors (2 screws on each door).
Insert the Freezer Door Panel
Lower the freezer panel until it slides into the slot behind the door panel.
Push the filler panel (required with some door panels) in behind the
decorator panel.
Reinstall the Top Trim on the Freezer Door
Using a T-20 Torx Driver, reinstall the two screws attaching the Top Trim.
Tighten two screws to 30 in-lbs torque.
Insert the Refrigerator Panel
Carefully push the panel in until it slides into the slot behind the door
handle. Push the filler panel (required with some door panels) in behind
the decorator panel.
Top Trim
Screw Holes
Cut out
Freezer
Panel
Refrigerator
Panel
Cut out
Blue
Tape Liner
Side Trim
Freezer
Side Trim
Refrigerator
Blue
Tape Liner
15