Saving Energy; Operating Noises; Completely Normal Noises; Preventing Noises - Bosch B1 CB Série Notice D'utilisation

en-us

Saving energy

Install the appliance in a dry, ventilated room. The
■
appliance should not be installed in direct sunlight or
in the vicinity of heat sources (e.g. radiator, cooker).
If required, use an insulating plate.
Allow warm food and drinks to cool down before
■
placing them in the appliance.
Thaw frozen food in the refrigerator compartment and
■
use the low temperature of the frozen food to cool
refrigerated food.
Open the appliance as briefly as possible.
■
To avoid increased power consumption, occasionally
■
clean the back of the appliance.
If available:
■
Fit wall spacers to obtain the indicated energy
absorption of the appliance (see Installation
instructions). A reduced wall gap will not restrict the
function of the appliance. The energy rating may then
increase slightly.
The arrangement of the fittings does not affect the
■
energy absorption of the appliance.

Rectifying minor faults yourself

Before you call customer service:
Check whether you can eliminate the fault yourself based on the following information.
Otherwise, you may be charged for a service repair as it would not be covered by the warranty.
Fault
Temperature differs greatly
from the set value.
The light does not work.
Controls have reduced lumi-
nosity.
Displays do not illuminate.
16
Possible cause
Light switch is jammed.
The light is defective.
When the appliance is not used for
some time, the display on the fascia
switches to energy saving mode.
Power cut;
the fuse has tripped; the mains plug
has not been inserted properly.

Operating noises

Completely normal noises

Droning
Motors are running (e.g. refrigeration units, fan).
Bubbling, humming or gurgling noises
Refrigerant is flowing through the tubing or water is
flowing into the ice maker.
Clicking
Motor, switches or solenoid valves are switching on/off.
Rumbling
Ready ice cubes from the ice maker are falling into
the ice cube container.

Preventing noises

The appliance is not level
Please align the appliance with a spirit level. Use the
height-adjustable feet or place packing underneath them.
The appliance is not free-standing
Please move the appliance away from adjacent units or
appliances.
Containers or storage areas wobble or stick
Check which parts are removable and, if necessary, re-
insert them correctly.
Bottles or receptacles are touching each other
Move the bottles or receptacles slightly away from each
other.
Remedial action
In certain cases it may be enough to switch off
the appliance for 5 minutes.
If the temperature is too high, wait a few hours
and check whether the temperature has
approached the set value.
If the temperature is too low, check the tempera-
ture again the next day.
Check whether the light switch can move.
(See chapter "Light".)
As soon as the appliance is again used, e.g. the
door is opened, the display switches back to nor-
mal illumination.
Connect the mains plug. Check whether the
power is on, and check the fuses.